Table of Contents
Advertisement
Mounting
4.2 Module mounting on a printed circuit board
4.2
Module mounting on a printed circuit board
Risk of serious injury.
No liability shall be accepted for any damage or injuries sustained as a result of improper
use or incorrect dismantling of the equipment (i.e. opening of components other than those
specifically designed to be opened by the user). Any improper handling of the equipment
can result in very serious physical injury.
Note
For use on printed circuit boards, special contact blocks and lampholders for soldering into
the printed circuit board are available. For this purpose, these contact blocks/lampholders
are fitted with 0.8 mm x 0.8 mm solder pins of length 3.5 mm.
①
②
③
④
⑤
⑥
16
WARNING
Actuating element
Front plate with minimum distances between actuators (see table below)
Spacing bolt
Holder
Lampholder or contact block
Printed circuit board
3SB2 pushbuttons and indicator lights
Configuration Manual, 05/2020, A5E43900767002A/RS-AA/001
Advertisement
Table of Contents
