Table of Contents
Advertisement
4.4
Mounting the contact block on a front plate
Mounting the entire module
1. Insert the actuator
(contact block holder).
2. Use the two clamping screws
cannot vibrate or twist. The maximum screw torque is 0.4 Nm. You can use front plates
with a thickness of between 1 and 6 mm.
With a front plate thickness
assembling the holder.
3. Insert the contact blocks
position. Any installation position is possible. One or two contact blocks can be mounted
on the holder.
4. Place the printed circuit board onto the solder pins of the contact blocks and lampholder
and solder it. After soldering, the devices must be flush with the board and perpendicular
to it.
3SB2 pushbuttons and indicator lights
Configuration Manual, 05/2020, A5E43900767002A/RS-AA/001
①
from the front through the opening and latch it with the holder
②
to securely fasten the holder
④
of > 3 mm, unscrew the clamping screws
⑤
into the locating groove at the side and snap them into
4.4 Mounting the contact block on a front plate
③
from the rear so that it
Mounting
③
②
before
19
Advertisement
Table of Contents
