Winter Storage; Long Term Storage; Rotect Fuel System - bar BAR4013C-HJ User Manual

Hide thumbs Also See for BAR4013C-HJ:
Table of Contents

Advertisement

STO A E
Thermal Relief Valve
1.
is open and discharg-
2.
ing water from side
of pump
1.
ump oil is low
1.
Oil has a milky color
1.
inter torage
ou must protect your unit from freezing temperatures.
1. Failure to do so will permanently damage your pump and render your unit
inoperable.
2.
ree ing damage is not co ered under
To protect the unit from free ing temperatures:
1. Use ump Saver to treat the pump. This minimizes freezing damage and lubricates
pistons and seals. Contact your local dealer for ump Saver Solution.
2. If pump saver is not available, connect a 3 ft. section of garden hose to the water inlet
adapter. our RV-antifreeze (antifreeze without alcohol) into hose. ull the recoil
handle twice. Disconnect the 3 ft. hose.
3. Store the unit in a clean, dry area (heated area preferred).
ong Term torage
If you do not plan to use the pressure cleaner for more than 30 days, you must prepare the
engined and pump for long term storage. See the engine user manual for specific instruc-
tions regarding this.
Protect uel ystem
Fuel Stabilizer:
Fuel will become stale when stored over 30 days. Stale fuel causes acids and gum
deposits to form in the fuel system or on essential carburetor parts. rior to storage, if
petrol will not be treated with a fuel stabilizer, it must be drained from the engine into an
approved container. After draining, run the engine until it stops from lack of fuel.
Water temperature is too high
ump has operated more than
3 mins without pulling trigger
hose, or gun
Normal use consumes oil over time
Seals have worn from use and water
has leaked in
NOTICE
1.
Use cool water only.
2.
ull trigger at least 30 seconds
every 3 mins. Thermal valve must
be replaced.
1.
gun If problem continues, take
to your pressure cleaner dealer
2.
Check quick connect for damaged or
lost O-rings and replace.
1.
To gauge the oil level, look directly
into the sight glass. Oil level should
always be at the center dot. Do not
detergent mineral oil
1.
Bring Unit to local service center to
have seals replaced
arranty
29

Advertisement

Table of Contents
loading

Table of Contents