Table of Contents
Advertisement
To apply detergent follo
1. Review the use of spray tips.
2.
repare detergent solution as required by the ob. See your BAR shop
for detergent options.
3.
lace the small filter end of detergent siphoning tube into detergent container or on-
board soap tank (if applicable).
4. Connect the other end of the soap hose to the pressure cleaner low pressure
detergent in ector.
NOTE Make sure the filter is fully submerged in detergent during use.
5. Ensure that the black spray tip is installed.
. Make sure the garden hose is connected to the water inlet. Check that the high
pressure hose is connected to spray gun and pump. Turn water on.
Please note that only the
ou must attach all hoses before you start the engine.
• Starting the engine without all the hoses connected and without the water
turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this instruction is not
covered by warranty.
7. Start the engine following instructions in Starting Your Cleaner.
8. Apply the detergent to the surface using long, even, overlapping strokes.
9. Allow the detergent to "soak in" before washing and rinsing. See
instructions on chemical for best procedure.
Reapply as needed to prevent surface from drying. O NOT allo
on
IM O TANT
the filter into a bucket of clean water and running the pressure cleaner at low pressure
for 1-2 minutes.
Chemicals can cause bodily harm and or property damage.
• NEVER use caustic liquid or acid with pressure cleaner.
• Use ONL pressure cleaner safe detergent soaps. Follow all
manufacturer instructions and do not mi detergents with other types.
26
SIN T E
these steps:
A
NO
E
ill dra
NOTICE
CA TION
AC SOA NO
soap.
detergent to dry
use by placing
E
Advertisement
Table of Contents
Troubleshooting
