Mounting Methods - Globalstar INTEGRITY 150 User Manual

9150-0126-01 R-2

MOUNTING METHODS

Use the following recommended procedures to mount the Integrity 150.
Mounting with the VHB tape:
The VHB tape is provided along with the Integrity 150 device. Please clean and dry the flat mounting surface before installation.
a. Peel off the protective cover from one side of the VHB tape. Please pay attention to the orientation of the tape to match the device orientation.
Stick the VHB tape to the cleaned surface and gently press it to ensure it stays secure.
b. Peel off the protective cover from the other side of the VHB tape.
c. Stick the magnetic puck assembly to the VHB tape dedicated circular cutout. Please make sure the magnetic side is facing up and the puck
stays within the cutout.
d. Stick the Integrity 150 device to the VHB tape and gently press it down to ensure it stays secure.
Mounting with the stainless-steel sled (Optional):
The stainless-steel sled must be ordered separately from Globalstar.
A. The stainless-steel plate has four reserved mounting holes for customers' needs. The hole patterns and size are shown below in
Figure 1, Mounting Plate Hole Pattern and Dimensions. Mount the stainless-steel sled to the asset with four screws of customer's
choice. The customer can choose their own screws to meet the mounting hole specs on the asset.
NOTE: The customer mounting screw head needs to be under the diameter of 9.3 mm (0.366") and under the height of 3.0 mm (0.118").
Integrity 150 User Manual
Figure 1: Mounting Plate Hole Pattern and Dimensions
Confidential & Proprietary Information
10