Globalstar INTEGRITY 150 User Manual page 13

9150-0126-01 R-2
I
In Motion – The unit is considered to be In Motion when there is a State of Vibration – and – the accelerometer status indicates there is motion.
Inaccurate GPS Reading – The longitude and latitude information obtained from processing the signals from the GPS satellites when a tracker
cannot observe an adequate number of satellites; the GPS signals were jammed by electronic interference; the GPS signals were reflected
from objects creating multi-path conditions; or weather conditions distorted the GPS signals. An inaccurate GPS reading may have longitude
and latitude errors of a mile or more.
Input – Mapped events in the Integrity 150 that monitors state changes. The Tamper switch is the only physical device input, ON/ OFF.
M
Message – A collection of information that is transmitted in a group over the satellite network.
Message Interval – The message interval indicates the amount of time specified by the user between Location Messages.
The Integrity 150 transmits a Location Message once the Message Interval has elapsed. The internal clock on the device is reset to the
interval time after each transmission. The Integrity 150 is in low power consumption mode during the interval to preserve battery life.
Message Time(s) of Day – The specific time of day in military format for the Integrity 150 to transmit Location Messages. The Integrity 150 is in
low power consumption mode between the specific times of day to preserve battery life.
Message Transmission –The process of sending a message over the satellite network. This includes sending a message multiple times to
improve the transmission success rate.
N
Number of message repeats – The number of times a message is sent for a message transmitted with the same Unique Message Number (UMN).
The number of message repeats is configurable during the tracker set up process. Globalstar only counts repeated messages as one message
if it is received three times or less. If the same message is received more than three times, Globalstar may count the message as more than
one message for billing purposes.
P
PV – Photovoltaic cells; the name of the cells contained in the Device panel.
S
Self Test – An internal unit test that is performed by the processor, checking for the proper operation of unit functions.
State of Lacking Vibration (SOLV) – The motion sensor is indicating a cease of vibration when the number of vibration pulses per minute is
lower than the Level of Sensitivity for Vibration Sensor number for the time required to determine if a State of Vibration has ceased. The
motion sensor is indicating that the vibration pulses per minute is lower than the Level of Sensitivity for Vibration Sensor for the configured
period of time.
State of Vibration (SOV) – The motion sensor is triggered when the number of vibration pulses per minute is above the Level of Sensitivity for
Vibration Sensor. The motion sensor is triggered when the vibration pulses per minute is above the Level of Sensitivity for Vibration Sensor for
the configured period of time.
Integrity 150 User Manual Confidential & Proprietary Information
13