3-10) Compressor - Samsung RR39M7 Series Service Manual

DISASSEMBLY & REASSEMBLY

3-10) Compressor

PART NAME
COMPRESSOR
Door Reed S/W
Note. Some models may not include the CONDENSER.
FIGURE
40
DESCRIPTION
1. Cut off the Lokring connecting the comp and the con-
denser or immersion pipe with a pipe cutter.
(Red-line marking point)
2. Cut off the LOKRING connecting the CONDENSER or im-
mersion pipe and the HOT PIPE with a Pipe Cutter. (Red-
line markign points)
3. Link the COMP and the CONDENSER or immersion pipe
with a PIPE-CONNECTOR (DA81-05659A) by brazing the
joint areas.
While brazing, place flame cover or Incombustible Sheet
behind the joint areas not to melt the Cabi Bottom.
4. Link the condenser or immersion pipe and the PIPE
CLUSTER-SIDE with a PIPE-CONNECTOR(DA81-05659B)
by brazing the joint areas.
While brazing, place flame cover or Incombustible Sheet
behind the joint areas not to melt the Cabi Bottom.
1. Disconnect the reed switch connectors.
Remove the cover control front
2. Using a flat head screwdriver, remove the reed switch.