DFI-ITOX G7L630-B User Manual page 79

IDE Primary Master/Slave UDMA and IDE Secondary Master/
Slave UDMA
These fields allow you to set the Ultra DMA in use. When Auto is
selected, the BIOS will select the best available option after checking
your hard drive or CD-ROM.
Auto The BIOS will automatically detect the settings for
you.
Disabled The BIOS will not detect these categories.
On-Chip Serial ATA Setting
On-Chip Serial ATA
Disabled
Auto
Combined Mode This option allows you to use both IDE and
Enhanced Mode This option allows you to use both IDE and
SATA Only
SATA Port Speed Settings
Force GEN 1
Force GEN 2
Disables the onboard SATA.
The system will detect the existing SATA and
IDE drives then automatically set them to the
available master/slave mode.
SATA drives; allowing a maximum of 4 drives -
1 IDE Master, 1 IDE Slave and 2 SATA. You
must manually set the SATA and PATA drives'
mode in the "PATA IDE Mode" and "SATA
Port" fields.
SATA drives; allowing a maximum of 6 drives -
1 IDE Master, 1 IDE Slave and 4 SATA.
This option automatically sets the SATA drives
to Primary Master mode. Since the SATA
drives are in Master mode, you cannot set the
IDE drive to Master mode.
SATA will run at 1.5Gb/s which is the first
generation SATA speed.
SATA will run at 3Gb/s which is the second
generation SATA speed.
3
BIOS Setup
79