DFI-ITOX G7L630-B User Manual page 28

2
Hardware Installation
2. Place the heat sink on top of the CPU. The 4 studs around the
heat sink which are used to secure the heat sink onto the
system board must match the 4 mounting holes around the
socket.
Position each stud so that the groove faces the heat sink then
push it down firmly until it clicks into place.
3. Connect the CPU fan's cable connector to the CPU fan connec-
tor on the system board.
28
Note:
You will not be able to secure the fan and heat sink
assembly in place if the groove is not facing the heat sink.
Mounting
hole
Mounting
hole
Groove
Mounting
hole
Mounting
hole
Fan
Heat sink
Stud