Table of Contents
Advertisement
HIGH EFFICIENCY DECATHLON (HD) SERIES GAS FRYERS
3.3 Installing Casters and Legs
A. Install casters and/or legs near where the fryer is to be used, as neither is secure for long
transit. Decathlon Series gas fryers cannot be curb-mounted and must be equipped with
either legs or casters provided.
B. After unpacking, use a pallet or lift jack to raise the unit before installing the casters.
C. Align the caster or leg base holes with the leg support assembly and insert bolt. Install
the washers and nut hand tight, and repeat for all four holes in caster/leg base assembly.
D. Tighten the caster/leg against the leg support assembly by using appropriate tools.
Ensure that all four bolts are evenly tightened. Tighten the bolts to 50 inch-lbs. (5.65 Nm)
torque.
E. For fryer with casters, there are no built-in leveling devices. The floor where the
fryers are installed must be level.
Front View
Front Channel
or Rear Channel
Front or Rear Leg with
Mounting Plate
Adjust as needed
Dean fryers equipped with legs are for permanent installations. Fryers fitted with
legs must be lifted during movement to avoid damage and possible bodily injury. For
a moveable or portable installation, Dean optional equipment casters must be used.
CHAPTER 3: INSTALLATION
Rear Side View
1/4-20 x 3/4 Hex Bolt
Front Channel or
Rear Channel
Leg Support Assembly
Washer
1/4-20 Hex Head Locknut
1/4-20 x 3/4 Hex Bolt
Caster/Leg Installation and Adjustment
WARNING
Questions? Call 1-800-551-8633.
3-2
Optional Caster-
Optional Caster-
Rear Only
Front Caster—5" Swivel
Rear Caster—5" Rigid
w/Brake
Front Only
Advertisement
Table of Contents
