Advertisement
ASSEMBLY
2
Turn the tank upside down and insert the two caster feet
into the front slots on the base. Apply downward pressure
to each caster. Casters will "snap" into place when
installed properly. Verify that the casters are mounted
correctly.
Insert the wheel axle into the base. Insert washer onto the
axle followed by rear wheel and insert washer again.
Insert the "R" locking pin into the hole on the end of the
axle to lock the wheel. Snap the hub cap on to the wheel.
Repeat the same steps at the other end of the axle.
3
Lightly squeeze together the ends of the rataining
bracket and click it into the motor housing.
Insert the rear handle into handle guides.
ACCESSORIES FITTING
4
Insert the large end of the hose into the front inlet of the
tank (before this, remove the rubber pad first).
The nozzles and brushes can install to the hose directly,
or extended by the telescopic wand and air regulator
tube.
OPERATION
DRY VACUUMING
Ensure that you read, understand, and apply the
safety instructions.
Reminder: DO NOT vacuum hazardous substances.
The use of an incorrect dust bag will invalidate the
warranty.
5
Install the supplied dust bag to the inner joint and
cartridge filter over the filter basket.
Plug the power cord into the power outlet and turn the
motor on by flipping switch to
position when finish vacuuming, and unplug the power
cord.
DO NOT USE THE CARTRIDGE FILTER FOR WET
OR SHARP MATERIALS.
DO NOT USE DUST BAG FOR LIQUID VACUUMING.
WARNING
position and off to
WARNING
WET
VACUUMING
Ensure that you read, understand, and apply the
safety instructions.
Reminder: DO NOT vacuum hazardous substances.
6
Install the supplied foam filter over the filter basket.
Plug the power cord into the power outlet and turn the
motor on by flipping switch to
position when finish vacuumming,and unplug the power
cord.
Empty and dry the tank.
The foam filter must be removed after wet vacuuming,
and a cartridge filter must be installed before dry
vacuuming again.
IMPORTANT!
When vacuuming large quantities of liquids, do not immerse
the nozzle completely in the liquid; leave a gap at the tip of
the nozzle opening to allow air inflow.
The machine is fitted with a float valve that stops the
suction action when the container reaches its maximum
capacity. You will notice an increase in the pitch of motor
sound. When this happens, turn of the machine, disconnect
from power supply, and drain the liquid into a suitable
receptacle or drain. To continue vacuuming, refit the
container with the drain cap. After wet vacuuming, turn the
machine off and remove plug from power supply.
Empty the container, clean and dry the inside and outside
before storage.
CONNECT ELECTRICAL APPLIANCES
7
Connect electrical appliance with Power Take Off on the
Vacuum, switch on electrical appliance, and flipping the
switch to
position. The vacuum cleaner will switch off
within 3-8 seconds once the electrical appliance switches
off.
The Drill Suction Nozzle is suggested to connect to the
hose and put on the wall where drilling when using an
electric drill, it can vacuum up the drilling dust directly at
the drill hole.
OVERLOAD PROTECTION
8
Overloading will activate the over current switch and cut
power to the take off. Press to reset the over current switch
to restore power to the take off.
3
WARNING
position, and off to
WARNING
.
Advertisement
