Ryobi R18SV7 Original Instructions Manual

Ryobi R18SV7 Original Instructions Manual

18v stick vacuum
Hide thumbs Also See for R18SV7:

Advertisement

ORIGINAL INSTRUCTIONS
18V Stick Vacuum
R18SV7

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the R18SV7 and is the answer not in the manual?

Questions and answers

jill martin
May 9, 2025

just received put together and brushes are not working

User image 681dcc6e1f883
1 comments:
Mr. Anderson
May 19, 2025

If the Ryobi R18SV7 brushes are not working after assembly, do the following:

1. Make sure the brushbar has been activated according to the instructions.
2. Check for any obstructions in the brushbar. Disconnect the vacuum cleaner and carefully remove any blockages.

This answer is automatically generated

Subscribe to Our Youtube Channel

Summary of Contents for Ryobi R18SV7

  • Page 1 ORIGINAL INSTRUCTIONS 18V Stick Vacuum R18SV7...
  • Page 2 Important! This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
  • Page 3: Intended Use

    This enables better control of the product in create a risk of fire. unexpected situations. Overreaching can result in loss Use RYOBI 18V ONE+ battery packs only. Do not use of balance or exposure to hot surfaces. battery packs from other manufacturers.
  • Page 4: Battery And Charger Safety

    Make sure cord is located so that it will not be stepped BATTERY AND CHARGER SAFETY on, tripped over, or otherwise subjected to damage and Connect and disconnect the battery pack properly. stress. To install battery pack: Do not crush, drop or damage battery pack. Do not use –...
  • Page 5: Residual Risks

    Replace the battery pack. ADDITIONAL BATTERY SAFETY WARNINGS To remove: WARNING Switch off unit and remove the battery pack. Depress locking tab and pull to remove. To reduce the risk of fire, personal injury, and product damage due to a short circuit, never immerse your To start the vacuum: press the ON/OFF button once for tool, battery pack or charger in fluid or allow a fluid to high speed.
  • Page 6: Symbols In This Manual

    Please read the instructions carefully before starting the machine. Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority or retailer for recycling advice. SYMBOLS IN THIS MANUAL Note Parts or accessories sold separately The following signal words and meanings are intended to explain the levels of risk associated with this product:...
  • Page 9: Know Your Product

    KNOW YOUR PRODUCT 1. On/off button 11. Receptacle 2. Handle 12. Release button 3. Battery port 13. Dust bowl door 4. Wall mount bracket 14. Lock button 5. Accessory holders 15. Brushbar 6. Hook 16. Dust brush 7. Dust bowl 17.
  • Page 18: Troubleshooting

    TROUBLESHOOTING PROBLEM POSSIBLE CAUSE SOLUTION Vacuum has no power. 1. The battery is not charged. 1. Charge the battery. 2. The motor thermostat may 2. Switch off the vacuum cleaner. Remove and have tripped. empty the dust bowl and check for blockages. Clean the filters and allow the vacuum cleaner to cool for approximately 1 hour (if you have washed the filters you will need to wait 24 hours...
  • Page 19: Product Specifications

    PRODUCT SPECIFICATIONS 18V Stick vacuum Model R18SV7 Voltage 18 V 595 L/min Dust storage capacity 500 ml Weight - excluding battery pack 1.45 kg...
  • Page 20 Imported by: Techtronic Industries Australia Pty Ltd 31 Gilby Road, Mount Waverley, VIC 3149 Melbourne, Australia Techtronic Industries N.Z. Limited 2 Landing Drive, Mangere Auckland, 2022, New Zealand 961075441-01...

Table of Contents

Save PDF