Table of Contents
Advertisement
No
Problem
6
Has odors.
7
Lint on clothes.
Items still wrinkled after
8
Wrinkle Prevent
(Wrinkle Away, Wrinkle Release).
Water drips from the nozzle
9
when the Steam cycles starts.
Sprayed water is not visible
10
during Steam cycles.
11
Extended time.
28 _ Troubleshooting
•
Household odors from paint, varnish, strong cleaners, etc. may enter the dryer with the surrounding
room air. This is normal as the dryer draws the air from the room, heats it, pulls it through the
tumbler, and exhausts it outside.
•
When these odors linger in the air, completely ventilate the room before using the dryer.
•
Use a cycle featuring the Refresh function. If odors persist, wash and dry the items again.
•
Make sure the lint filter is cleaned before every load. For clothes that naturally build up lint,
clean the filter during the cycle.
•
Some fabrics are lint producers (for example, a fuzzy white cotton towel) and they must be
dried separately from clothes that are lint trappers (for example, a pair of black linen pants).
•
Divide larger loads into smaller loads for drying.
•
Check pockets thoroughly before drying, then dry clothes.
•
Remove lint inside the drum before drying a load.
•
Small loads of 1 to 4 items work best.
•
Load fewer items. Load similar-type items.
•
Take out the items immediately after drying is complete.
•
This is steam condensation.
•
The dripping water will stop after a short time.
•
Sprayed water is difficult to see when the door is closed.
•
Sensor Dry automatically senses the moisture in the load and shuts the dryer off when the
selected dryness level is reached. The drying time can change according to the type and
amount of laundry. See the cycle chart for reference.
What to do
Hide quick links:
Advertisement
Table of Contents
