Advertisement
PIR detector switch
7. SETTINGS (continued)
- Modifying the parameters using the configuration tools
(continued)
• 0 882 30: Configuration tool
When the sensor receives an IR command via a configuration tool,
it emits a beep confirming that the modification has been taken into
account.
For more information about setting parameters, refer to the data sheet
for the configuration tool Cat. No. 0 882 30.
As from 01/01/2022, this
product ref. 0 882 30 is no
longer sold.
- Restore to factory settings:
1
press: Short press on LEARN: the LED flashes slowly.
st
2
nd
press: Press and hold down LEARN for 10 seconds until the
LED flashes quickly.
8. PERFORMANCE
Height
Ø
Technical data sheet: S000100487EN_2
CONTENTS
8. PERFORMANCE (continued)
Ø (m)
2.5
4
3
5.5
4
6.5
5
6
6
4
Ø (m)
2.5
6.5
3
8.5
4
12.5
5
12
6
8.5
9. CLEANING
Ensure the lens remains clean.
Surface cleaning using a cloth.
Do not use: acetone, tar remover, trichloroethylene.
Resistant to the following products: - Hexane (EN 60669-1),
WARNING : Conduct preliminary tests before using any other
specific cleaning products.
10. STANDARDS
Directive: CE
Installation standards: NFC 15-100
Product standards: IEC 60669-2-1
Environmental standards:
- European Directive 2002/96/EC:
WEEE (Waste Electrical and Electronic Equipment).
- European Directive 2002/95/EC:
RoHS (Restriction of Hazardous Substances).
- Decrees and/or regulations: ERP (public buildings)
Updated: 26/01/2023
Catalogue Number(s): 0 488 07
Sensitivity
Sensitivity
Low (25%)
Medium (50%)
Surface area (m²)
Ø (m)
15
6
25
6.5
35
7.5
30
10.5
15
5.5
Sensitivity
Sensitivity
High (75%)
Very-high (100%)
Surface area (m²)
Ø (m)
30
8
60
11.5
125
14
115
16.5
60
12.5
- Methylated spirit,
- Soapy water,
- Diluted ammonia
- Bleach diluted to 10%,
- Window cleaning products.
ERT (professional buildings)
IGH (high-rise buildings)
Created: 18/05/2010
Surface area (m²)
25
35
45
90
25
Surface area (m²)
50
100
155
215
125
4/4
Advertisement
