H3C WX Series Getting Started Manual page 12

interface NULL0
#
interface Vlan-interface1
ip address 192.168.0.100 255.255.255.0
#
interface GigabitEthernet1/0/1
#
interface GigabitEthernet1/0/2
#
interface GigabitEthernet1/0/3
#
interface GigabitEthernet1/0/4
#
interface Ten-GigabitEthernet1/0/5
#
load xml-configuration
#
user-interface con 0
user-interface vty 0 4
authentication-mode scheme
user privilege level 3
#
return
Table 5-1 Description of the default configuration
version 5.20, Release 2106P01
sysname H3C
undo info-center logfile enable
domain default enable system
telnet server enable
port-security enable
vlan 1
domain system
access-limit disable
state active
idle-cut disable
self-service-url disable
user-group system
local-user admin
password simple admin
authorization-attribute level 3
service-type telnet
Field
The AC software version currently in use
The default sysname is H3C.
Disable the logfile function.
The default enabled domain is system.
By default, telnet server is enabled.
By default, port security is enabled.
VLAN 1 is the default VLAN, and you cannot create and
delete a default VLAN.
Basic configurations in the default domain system:
The number of associated clients is not limited.
Specify the current domain to be in the active state.
Disable the idle-cut function for the current ISP domain.
Disable the location function of the self-service server.
system is the default user group. You cannot delete the
default user group but you can modify its configuration.
The default configuration of the local user is as follows:
The username is admin.
The password is admin, case sensitive.
The user level is 3 (manage level).
The service type is telnet.
5-2
Description