BPC instruments AMPTS III Operation And Maintenance Manual page 25

The control tab is where direct interaction with the channels and motors are conducted
(Figure 16). Using the Aurora
channels.
Located at the bottom right of the lines section is the control panel for the flow cell units.
These work as follows
Regarding the agitation system,
(double) modes. With the two-phase mode, the motors can run intermittently at two different speeds
or as ON and OFF (Figure 17).
TM
software, it is possible to start and stop all or just selected
Figure 16. Full description of each line of the Control page.
:
the motors can be controlled in continuous (single) or two-phase
25