Power Connections - Zodiac E30 iQ Installation And Maintenance Manual

3.3 POWER CONNECTIONS

•
Always disconnect the power source before working on a motor or its connected load.
•
Only a qualified and experienced technician is authorised to carry out any service,
including cabling work within the appliance.
•
To prevent overheating of the terminal board, which could create a fire hazard,
check that all terminals have been properly tightened. Loose terminals will void
the warranty.
•
The appliance must connect to the Earth.
•
Any unsuitable electrical connection wil invalidate the warranty.
Detail A
1/2" NPT Threaded
Low Voltage
Dry Contact Ports
VOLTAGE CHECKS
Install the pump per the correct voltage as specified on the pump data plate.
Installation and general maintenance manual
Bonding Lug
Dry Contact
(See Section 3.5)
Power and Ground
RS-485
Dip
Connector
Switches
3-4
(see
Detail A)
Low Voltage
Section
FIGURE 5 - Connection Diagram
- VARIABLE SPEED PUMP
Terminal Block
1/2" NPT
High Voltage
Threaded
Section
High Voltage
Conduit Ports
29