ADDITIONAL INFORMATION
Troubleshooting
If you experience a problem with your device, please refer to the following information. If a problem persists, please
contact your local reseller or service center.
No picture or sound.
•
Make sure all signal and power connections are properly connected.
•
Make sure the correct input mode is selected. Refer to the "Shortcut Menu" section.
•
Make sure the IFP is not turned off.
•
Turn off the mute function.
•
Make sure the volume is not set to the minimum level.
The IFP automatically shuts down.
•
Check whether there is a sudden power outage.
•
Make sure the power cord is not disconnected.
The signal is out of range
•
The signal may be incompatible. Refer to the "Supported Timing List" section.
•
For the VGA input source, press the
adjust the Frequency and Phase settings in OSD Signal menu.
The touch panel does not respond
•
Make sure the screen is not exposed to direct sunlight or other strong light.
•
For the external device connection, make sure the USB cable is properly connected to the Touch USB
port of the IFP.
If the remote control does not work
•
Check that the operating angle of the remote control is pointed within ±30° to the IR receiver on the IFP.
•
Make sure there are no obstructions between the remote control and the IFP. The distance between
the remote control and the IR sensor window should not be longer than 8 meters.
•
Make sure batteries are inserted correctly and replace the batteries if they are depleted. Refer to the
"Installing/Replacing the Remote Control Batteries" section.
key on the remote control to automatically adjust the screen or
121
English