Transfer Case; Hoisting; Tires; Tire Safety Information - Dodge RAM 1500 2020 Owner's Manual

T C
RANSFER ASE
Selection Of Lubricant
Use only the manufacturer's recommended fluid. Refer to
"Fluids And Lubricants" in "Technical Specifications" for
further information.
Fluid Level Check
This fluid level can be checked by removing the filler plug.
The fluid level should be to the bottom edge of the filler
plug hole (or within 1/8 inch of the bottom) with the
vehicle in a level position.
Drain And Refill
Refer to the "Maintenance Plan" in this section for the
proper maintenance intervals.

HOISTING

A conventional floor jack may be used at the jacking
locations. Refer to the graphics that show jacking
locations. However, a floor jack or frame hoist must never
be used on any other parts of the underbody.
CAUTION!
Never use a floor jack directly under the differential
housing of a loaded truck or damage to your vehicle
may result.

TIRES

T S I
IRE AFETY NFORMATION
Tire safety information will cover aspects of the following
information: Tire Markings, Tire Identification Numbers,
Tire Terminology and Definitions, Tire Pressures, and Tire
Loading.
Tire Markings
Tire Markings
1 — US DOT Safety Standards Code (TIN)
2 — Size Designation
3 — Service Description
4 — Maximum Load
5 — Maximum Pressure
6 — Treadwear, Traction and
Temperature Grades
SERVICING AND MAINTENANCE
NOTE:
 P (Passenger) — Metric tire sizing is based on US design
standards. P-Metric tires have the letter "P" molded
into the sidewall preceding the size designation.
Example: P215/65R15 95H.
 European — Metric tire sizing is based on European
design standards. Tires designed to this standard have
the tire size molded into the sidewall beginning with the
section width. The letter "P" is absent from this tire size
designation. Example: 215/65R15 96H.
 LT (Light Truck) — Metric tire sizing is based on US
design standards. The size designation for LT-Metric
tires is the same as for P-Metric tires except for the
letters "LT" that are molded into the sidewall preceding
the size designation. Example: LT235/85R16.
 Temporary spare tires are designed for temporary
emergency use only. Temporary high pressure compact
spare tires have the letter "T" or "S" molded into the
sidewall preceding the size designation. Example:
T145/80D18 103M.
 High flotation tire sizing is based on US design stan-
dards and it begins with the tire diameter molded into
the sidewall. Example: 31x10.5 R15 LT.
293
7