Table of Contents
Advertisement
T
S
T
E
W
O
TART
HE
NGINE
HILE
A
M
UTOSTOP
ODE
While in DRIVE, the engine will start when the brake pedal
is released or the throttle pedal is depressed and the
transmission will automatically reengage upon engine
restart.
Conditions That Will Cause The Engine To Start
Automatically While In Autostop Mode
The engine will start automatically when:
The transmission selector is moved from DRIVE to
REVERSE, NEUTRAL, or PARK
To maintain cabin temperature near the HVAC settings
HVAC is set to full defrost mode
12 Volt demand requires engine restart
Low brake vacuum (e.g. after several brake pedal appli-
cations)
STOP/START OFF switch is pushed
4WD system is put into 4L mode
The emissions system override is present
A STOP/START system error present
Conditions That Force An Automatic Shift To Park While In
Autostop Mode
The engine will not start automatically and the
transmission will be placed in PARK if:
The driver door is open and brake pedal released.
The driver door is open and the driver seat belt is
unbuckled.
I
The engine hood has been opened.
N
A STOP/START system error present.
The engine may then be restarted by moving the
transmission shift selector out of PARK (e.g. to DRIVE) or,
in some cases, only by a KEY START. The instrument
cluster will display a SHIFT OUT OF PARK message, or a
STOP/START KEY START REQUIRED message, to indicate
which action is required.
Refer to "Instrument Cluster Display" in "Getting To Know
Your Instrument Panel" for further information.
T
M
O
ANUALLY
S
S
TART
YSTEM
1.
Push the STOP/START OFF switch (located near the
gear selector). The light on the switch will illuminate.
STOP/START OFF Switch
T
O
T
S
URN
FF
HE
TOP
STARTING AND OPERATING
2.
The STOP/START OFF message will appear in the
instrument cluster display. Refer to "Instrument
Cluster Display" in "Getting To Know Your Instrument
Panel" for further information.
3.
At the next vehicle stop (after turning off the STOP/
START system) the engine will not be stopped.
4.
If the STOP/START system is manually turned off, the
engine can be started and stopped by cycling the
ignition switch or pressing the STOP/START switch
again.
5.
The STOP/START system will reset itself back to an
ON condition every time the key is turned off and back
on.
T
M
T
O
T
O
ANUALLY
URN
N
HE
S
S
TART
YSTEM
1.
Push the STOP/START OFF switch (located near the
gear selector module).
2.
The light on the switch will turn off.
S
M
YSTEM
ALFUNCTION
If there is a malfunction in the STOP/START system, the
system will not shut down the engine. A "SERVICE STOP/
START SYSTEM" message will appear in the instrument
cluster display. Refer to "Instrument Cluster Display" in
"Getting To Know Your Instrument Panel" for further
information.
The system will need to be checked by an authorized
dealer.
187
5
S
TOP
Advertisement
Table of Contents
