Table of Contents
Advertisement
CAUTION!
When installing the power distribution center cover,
it is important to ensure the cover is properly posi-
tioned and fully latched. Failure to do so may allow
water to get into the power distribution center and
possibly result in an electrical system failure.
When replacing a blown fuse, it is important to use
only a fuse having the correct amperage rating. The
use of a fuse with a rating other than indicated may
result in a dangerous electrical system overload. If a
properly rated fuse continues to blow, it indicates a
problem in the circuit that must be corrected.
JACKING AND TIRE CHANGING
WARNING!
Do not attempt to change a tire on the side of the
vehicle close to moving traffic. Pull far enough off the
road to avoid the danger of being hit when operating
the jack or changing the wheel.
Being under a jacked-up vehicle is dangerous. The
vehicle could slip off the jack and fall on you. You
could be crushed. Never put any part of your body
under a vehicle that is on a jack. If you need to get
under a raised vehicle, take it to a service center
where it can be raised on a lift.
Never start or run the engine while the vehicle is on
a jack.
The jack is designed to be used as a tool for changing
tires only. The jack should not be used to lift the
vehicle for service purposes. The vehicle should be
jacked on a firm level surface only. Avoid ice or slip-
pery areas.
NOTE:
If your vehicle is equipped with an air suspension system,
there is a feature which allows the automatic leveling to be
disabled to assist with changing a tire.
This feature can be activated through the Uconnect
system.
Refer to "Uconnect Settings" in "Multimedia" for further
information.
J
L
ACK
OCATION
The jack and tools are stored under the front passenger
seat.
R
O
J
EMOVAL
F
ACK
To access the jack and jack tools, you must remove the
plastic access cover located on the side of the front
passenger's seat. To remove the cover, pull the front part
of the cover (closest to the front of the seat) toward you to
release a locking tab. Once the front of the cover is loose,
slide the cover toward the front of the seat until it is free
from the seat frame.
(Continued)
WARNING!
Remove the jack and tools by turning the wing bolt
counterclockwise, remove the wing bolt and then slide the
assembly out from under the seat.
A
T
ND
OOLS
IN CASE OF EMERGENCY
Pull Jack Access Cover From Front
Jack And Tools
253
6
Advertisement
Table of Contents
