Table of Contents
Advertisement
CHAPTER 3. Ubigate iBG1000 Installation
Installing on a Wall
This section describes how to install Ubigate iBG1000 on a wall.
1.
Mark two holes, horizontally or vertically, on a desired wall. The hole
distance is about 130 mm.
2.
Make holes on the marked position with an electric drill. Make the depths
and the diameters of the holes more than 33 mm and around 5.5 mm to
insert the plastic anchors easily, respectively.
3-2
Figure 3.1 Making holes
© SAMSUNG Electronics Co., Ltd.
Advertisement
Table of Contents
