BRP BUDS2 User Manual page 10

Each module shows different status icons:
Toolbar
In the toolbar, shown on the top of the window, you can select the task you want to perform next.
Scan
To scan a vehicle connected via the VCI, select 'Scan' in the toolbar. A progress dialog shows you the
progress of the scanning process. Pressing 'Cancel' in the progress dialog will stop the scanning process
and clear all data which has already been read. The scanning is not interruptible at any time and, thus,
cancellation may not respond immediately.
Figure 19: Vehicle diagnostic dashboard
Module is in boot mode
Module is in boot mode and application is valid;
or fault codes or firmware updates have been found
Module is not in boot mode and application is valid.
No fault codes or valid firmware updates available
Optional or recommended flash file
Mandatory flash files
Occurred fault codes found
Active fault codes found
Figure 20: Toolbar
9