Location Requirements
WARNING
Explosion and Fire Hazard
Keep flammable materials and vapors, such as
gasoline, away from appliance.
Failure to do so can result in death, explosion or fire.
This refrigerator is designed for
IMPORTANT:
indoor, household use only.
Temperature
This refrigerator is intended for use in a location
where the temperature refers to nameplate . The
preferred room temperature range for optimum
performance, which reduces electricity usage and
provides superior cooling, is between 16°C and 32°
C. It is recommended that you do not install the
refrigerator near a heat source, such as an oven or
radiator.
Installation Instructions
Unpack the Refrigerator
WARNING
Fire or Explosion Hazard
Do not puncture refrigerant tubing.
Follow handling instructions carefully.
Flammable refrigerant used.
Failure to do so can result in death, explosion or fire.
IMPORTANT: Handle with care when moving
refrigerator to avoid either damaging the
refrigerant tubing or increasing the risk of a leak.
14
Electrical Requirements
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove the ground prong from the power
cord plug.
Do not use an adapter.
Do not use an extension cord.
Failure to do so can result in death, fire or
electrical shock.
Before you move your refrigerator into its final
location, it is important to make sure you have the
proper electrical connection.
Recommended Grounding Method
A 220-240 volt, 50/60Hz(please refer to nameplate),
AC only 15- or 20-amp fused, grounded electrical
supply is required. It is recommended that a separate
circuit serving only your refrigerator be provided. Use
an outlet that cannot be turned off by a switch. Do not
use an extension cord.
NOTE: Before performing any type of installation or
cleaning, disconnect the refrigerator from the
electrical source. When you are finished, reconnect
the refrigerator to the electrical source and reset the
temperature controls to the desired setting.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
refrigerator.
Failure to do so can result in back or other injury.
Remove the Packaging
Remove tape and glue residue from surfaces
before turning on the refrigerator. Rub a small
amount of liquid dish soap over the adhesive
with your fingers. Wipe with warm water and
dry.