Page 1
Refrigerator Service manual MODEL: RS-36DR*(BCD-275Q) NOTE: This is a basic model.the shape and specification of refrigerator is subject to change.
Contents Parts Description ................................3 Circuit diagram ................................3 Cooling diagram ................................4 The guide for Disassembly Common parts of Refrigerator ..................5 ◆ The instruction of replacing thermostat......................... 5 ◆ The instruction of replacing lamp.......................... 5 ◆ The instruction of replacing Door switch......................6 ◆...
Parts Description 1.Temperature regulator 2.Storage shelf. 3.Crisper Cover 4.Crisper 5.Upper Drawer in freezer 6.Middle Drawer in freezer 7.Lower Drawer in freezer 8.Upper Door shelf 9.Lower Door shelf Circuit diagram...
The guide for Disassembly Common parts of Refrigerator ◆ The instruction of replacing thermostat. The location of the thermostat Remove screws of thermostat box Unplug the connecting wire Take out the thermostat ◆ The instruction of replacing lamp. The location of the LED lamp The operation of replacing LED lamp is...
1、 Remove the LED lamp cover 2、 Take out the lamp ◆ The instruction of replacing Door switch. The location of door switch Take out the door switch with a screwdriver ◆ The instruction of replacing PTC Starting relay and Overload protector. Take down Spring tap and Cover.
Unplug the connecting wire Take out the PTC Starting relay and Overload protector Troubleshooting ◆ The common problem judging method Problem Cause 1.1 Is the power cord connecting well? 1.2 Is the power voltage too low? 1.3 Is the ambient temperature too low? Refrigerator can’t 1.4 Is the circuit on power? start...
3.9 Does the gas leak? 4.1 Is the setting of the temperature appropriate? 4.2 Is there multi-moisture food and too close to the back wall of the refrigerator? Ice up in the freezing 4.3 Is the ambient temperature too low? chamber 4.4 Is the electric parts on good condition, specially the thermostat wich will cause the unit non-stopping...
Page 9
well. finally sealed the system. Phenomenon of failure: a, higher pressure of liquid cycle system than norm. b, higher temperature of condenser. c, larger electric current of compressor d, there maybe ice on the suction tube. e, when gas is too much, some gas liquid might goes back into compressor, compressor will be damaged by liquid.
Page 10
that blocked the liquid Sometime because unknown open charging tube, discharge all of gas. cycle system reason water comes into liquid Blow the cycle system with gas of nitrogen, and then recharge Gas, finally sealed the cycle system, the capillary will be blocked by water after unit runs for system.
5)Wind door is broken. Replace wind door. 6)Fan motor is broken. Replace fan motor Note: ● Before doing these operations above, disconnect the main power supply. Failure to do so could result in electrical shock or personal injury. ● In case of any detailed technical information please check with the technical specifications.