Technical Data - Kayoba 002-400 Operating Instructions Manual

EN
• This equipment can be used by children
from 8 years and upwards and by persons
with physical, sensorial or mental
disabilities, or persons who lack
experience or knowledge, if they are
supervised or receive instructions
concerning the safe use of the equipment
and understand the risks involved with its
use. Do not allow children to play with the
equipment. Do not allow children to clean
or maintain the equipment without
supervision. Do not touch hot parts. Use
the handles and knobs.
• Keep children under supervision to make
sure they do not play with the equipment.
ELECTRICAL SAFETY
• Always take basic safety precautions when
using electrical appliances to reduce the
risk of fire, electric shock and/or personal
injury.
• Always check before using that the power
cord and plug are undamaged. Do not
use the equipment if the power cord or
plug are damaged. A damaged cord or
plug must be replaced by an authorised
service centre or qualified person to
ensure safe use.
• Do not touch the plug or power cord with
wet hands or other wet parts of your body.
• Place the power cord so that it cannot be
stood on, or clenched.
• Only use the supplied power cord and plug.
• The equipment must be earthed,
otherwise there is risk of electric shock.
SYMBOLS
Description of symbols used on the product. Familiarise yourself with
them to reduce the risk of personal injury and material damage.
Approved in accordance with
the relevant EU directives.
Sort at source as electrical waste.
38

TECHNICAL DATA

Rated voltage
Max load
Speed
Number of programmes
Connections
Treadmill surface
Dimensions
Weight
ASSEMBLY
NOTE:
Remove the safety catch before assembly.
1. Open the packaging, unpack the machine, remove all
packaging material and check that all the parts are included
according to the list below. Place the machine upright on the
ground or floor, NOT lying on its side.
2. Remove the screw (A) and safety catch (B) using a 5 mm hex
key (12).
FIG. 1
No. Designation
1 Motor unit
55 Serrated lock washer
39 Hex screws with round head (M8 x 15)
11 Spanner (13, 14, 15 mm)
12 Hex key (5 mm)
34 Cover, right side piece
4 Left side piece
5 Right side piece
22 Computer unit
33 Cover, left side
34 Cover, right side
83 Bottle cage
84 Screw
FIG. 2
3. Open the pack and place the motor unit on the floor.
FIG. 3
4. Fit the left and right side pieces (4), (5) on the motor unit
with the hex screws (39) and washers (55). Connect the
middle cable to the lower cable.
FIG. 4
5. Fit the motor unit (22) on the left and right side pieces
with the hex screws (39) and washers (55). Connect the
computer unit cable to the middle cable.
FIG. 5
NOTE:
Check and tighten all screw unions. Read all the instructions
and safety instructions carefully before use.
6. Fit the covers (33) and (34) on the left and right side pieces.
FIG. 6
230 V ~ 50 Hz
100 kg
0-12 km/h
9
Bluetooth/3.5 mm audio cable
122 x 40 cm
158 x 72 x 122 mm
47 kg
Qty
1
10
10
1
1
1
1
1
1
1
1
1
2