Wired Lan (Ql-820Nwb Only) / Wireless Lan Tabs - Brother QL820NWBC User Manual

Changing the Label Printer Settings

Wired LAN (QL-820NWB only) / Wireless LAN Tabs

The following explains about the Wired LAN (QL-820NWB only) and Wireless Tab in the Settings Dialog Box.
TCP/IP (Wired/Wireless)
• Boot Method
Selects [AUTO], [BOOTP], [DHCP], [RARP], or [STATIC].
• IP Address/Subnet Mask/Gateway
Specifies the various networking values.
You can enter these settings only when the IP address is set to [STATIC].
• DNS Server Method
Selects [AUTO] or [STATIC].
• Primary DNS Server IP Address/Secondary DNS Server IP Address
You can enter these settings only when the DNS server is set to [STATIC].
IPv6
• Static IPv6 Address
Specifies a permanent IPv6 address.
• Enable this address
Enables the specified static IPv6 address.
• Primary DNS Server IPv6 Address/Secondary DNS Server IPv6 Address
Specifies the DNS server IPv6 addresses.
• IPv6 Address List
Displays the list of IPv6 addresses.
Wireless Settings
• Communication Mode
Selects [Infrastructure] or [Ad-hoc].
• SSID (Network Name)
Clicking [Search] displays the available SSID selections in a separate dialog box.
• Channel
Lists available channels.
Note
This setting is valid only in Ad-Hoc mode.
• Authentication Method/Encryption Mode
The supported encryption modes for the authentication methods are as shown in Communication Modes
and Authentication Methods/Encryption Modes on page 47.
• WEP Key
You can specify a setting only when WEP is selected as the encryption mode.
• Passphrase
You can specify a setting only when WPA/WPA2-PSK is selected as the authentication method.
4
4
4
4
4
46