Maintenance And Servicing; Daily Maintenance; Periodic Inspection - TE Connectivity HT11K Operating Instructions Manual

5 Customer Service, EMEA Service Hotline
Please contact us for service enquiries or technical support:
Monday - Thursday
Friday
Tel.
www
www
_____________________________________________
TE Connectivity Germany GmbH
c/o Schenck Technologie- und Industriepark GmbH
Landwehrstr. 55 / Gebäude 83
64293 Darmstadt
Germany
Additional information and contact details can also be found online.
Visit us at:
6

Maintenance and servicing

6.1

Daily maintenance

The following daily maintenance tasks should be performed by the responsible operator:
Using a soft, clean brush or a lint-free cloth, remove dirt, dust, moisture and other residue
from the hand tool. Do not use any hard or abrasive tools or materials that could damage
the hand tool.
Apply sewing-machine oil to all pivot points and bearing surfaces. Do not lubricate exces-
sively.
When the hand tool is not needed, store it in a clean and dry location.
6.2

Periodic inspection

The hand tool should be inspected periodically by suitably qualified staff according to the
level of use, and the inspections should be documented.
Check the hand tool for wear and damage, particularly in the crimping nest areas.
HT11K Hand Tool MCON050, 0.13 – 0.35 mm²
8am - 4pm
8am - 2pm
+49 (0) 6151 607 -1518
TEFE1@TE.COM (EMEA Customer Support)
TEFE2@TE.COM (EMEA Hand Tool Repair)
http://tooling.te.com/
Page 7 - 7 Operating Instructions
411-18539-1 Rev.B