Table of Contents
Advertisement
Mounting the ejector on a base
ü Ensure that the ejector is completely resting on the base during mounting and is fastened without distortion
and tension.
4 Secure the ejector (1) to the base with at least 2
fastening screws (2) (M4, torque = 0.7 Nm) and the
corresponding washers.
6.3 Pneumatic Connection
CAUTION
Compressed air or vacuum in direct contact with the eye
Severe eye injury
4 Wear eye protection
4 Do not look into compressed air openings
4 Do not look into the silencer air stream
4 Do not look into vacuum openings, e.g. suction cups
CAUTION
Noise pollution due to incorrect installation of the pressure and vacuum connections
Hearing damage
4 Correct installation.
4 Wear ear protectors.
8 / 10
EN-US · 30.30.01.00021 · 02 · 06/22
Advertisement
Table of Contents
