Advertisement
5.
Pass the cords of the sensor pads through special openings in the holder (see illustration 4 and 5).
Attach sensor pad connectors to the outlets marked "SENSOR" on the back of control unit
6.
(see illustration 6 and 7).
PLEASE NOTE: Do not insert any cable into the blocked socket, marked "DO NOT USE" (see illustration 7)
7.
Should the design of the crib not allow proper installation with the control unit holder, please use the
supplied hanging hook (see illustration 6). Hang the control unit from the bottom edge of the crib or affix
the hook with a screw (not supplied) to the bottom edge of the crib and hang the control unit from the
bottom edge of the crib.
IMPORTANT: To avoid possible danger from sensor cords, ensure that excess cords are pulled back under
the mattress, secured with the included cable tie and are not visible or reachable.
Advertisement
