Advertisement
Layout of Control Unit
See illustration 8 for layout of control unit:
Lower LED
• Green Movement
indicator light flashes
• Red flashing LED:
Visual alarm
Operation
WARNING: Please note that the green LED (power indicator) is not an indicator for movements of the baby.
It only indicates that the Babysense Connect Monitor is ON. When movement is sensed, the green
movement LED light flashes.
Babysense is ready for operation and use once the installation is completed. To operate, follow the below
instructions:
Place your baby in crib/bed.
Turn control unit on by pressing ON/OFF button.
Make sure Green Power Indicator LED is illuminated briefly.
When any movement is sensed, the green movement light flashes. NOTE: This is not an indication of the
baby's movement rate but that movement is being sensed.
Acoustic and visual red alarm light are activated if the baby's movement stops or slows significantly.
If Orange LED light flashes in 5 second intervals and Green Power LED is on (low-battery warning), replace
all batteries as soon as possible. If the Orange LED continuously flashes with no Green Power LED, all
batteries must be replaced immediately or fully charge the rechargable batteries
( www.babysensemonitors.com/pages/bs-connect-batteries for applicable list).
Turn off control unit by pressing ON/OFF Power Button before taking your baby out of the crib / bed. Make
sure the Green LED is off and no other lights are seen thereafter, to indicate the device is turned off.
Note: Ensure that the auditory alarm can be heard in all locations throughout the home or place of care
and that the Babysense Connect Control Unit is hung with the LEDs facing out so that they are easily visible.
Testing Operation
Babysense Connect is a highly sensitive device, which monitors a baby's movements through the mattress
during sleep. There are two main causes of malfunction - technical malfunctions and malfunctions due to
environmental factors.
Upper LED:
• Green LED: power indicator
LED
• Orange
flashes at 5 second intervals
alternating with the Green Power Indicator
On/Off
LED: low battery indication
power button
• Orange LED flashes continuously: critical
low battery indication
• Red flashing LED: Visual alarm
• Blue LED:
• Purple LED: updating software
activation
8
Advertisement
