Advertisement
Babysense Connect
Non-Contact Movement Monitor
Warnings
Ensure you read this user manual before installing and using the product.
Babysense is a high quality, high sensitivity electronic device, which must be handled with care:
Do not handle roughly, drop or throw.
Follow the installation instruction carefully to ensure the device is installed securely and correctly.
Babysense is not a toy. Do not allow children of any age to play with it.
Do not put any additional baby or pet in the bed.
Babysense Connect is intended for use with one infant and cannot be used for two infants in one bed.
Babysense Connect cannot be used with co-sleepers that are attached to the parent's/caregiver's bed.
Do not operate the unit in the presence of electromagnetic interference.
Portable and mobile RF communications equipment may e ect operation of this device.
You must undertake the performance test daily and every time you move the monitor, change bedding
or relocate crib/bed position (Daily Performance Test Section).
Do not operate vaporizer or ventilator directly towards the bed.
To avoid possible danger from sensor cords, ensure that excess cords are pulled back under the
mattress, secured with the included cable tie and are not visible or reachable.
Install 4 new and identical Alkaline size AA 1.5 volt batteries.
NOTE: Rechargable batteries may be used - www.babysensemonitors.com/pages/bs-connect-batteries for
applicable list. The batteries must be fully charged before inserting in the Babysense Control Unit
Please remove batteries if the device is not in use for an extended time (2 weeks or more).
When using the device after having not used it for an extended period of time please install 4 new
identical Alkaline AA Batteries or fully charge and insert the rechargable batteries
( www.babysensemonitors.com/pages/bs-connect-batteries for applicable list.).
If you have any problems with this device, such as setting up, maintaining or using, please
contact the manufacturer's service personnel. Also, please report to the manufacturer if any unexpected
operation or events occur.
Do not use the equipment if you notice a change in the system's performance, if the system is
damaged, or if any of its components are worn or frayed.
The equipment should not be used adjacent to or stacked with other equipment. If adjacent or stacked
use is necessary, the equipment should be observed to verify normal operation in the configuration in
which it is used.
SAFETY INSTRUCTIONS FOR HUB AC POWER ADAPTER
•
The adapter should not be exposed to direct heat sources such as a candle, stove, radiator, heat
register or other appliance that emits heat.
During continual use, the power adapters may become warm to the touch.
•
Examine intactness of the power cord and its plug.
•
The adapter must be handled with care: Do not handle roughly, drop or throw.
•
Once removing the power adapter from the wall outlet, hold and pull from the receptacle. Do not pull
•
on the cable itself or bend the cable as that will put additional stress on the cable and could lead to
damages.
Do not touch the power adapter with wet hands or allow liquids to spill on it.
•
•
Make sure the mains adaptor cables are kept out of reach of your baby and other young children at all
times. To avoid possible danger from power cords, the cords should be secured and never be hung
on or near the crib.
•
Do not replace the plugs or cable on your power adapter. This product should only be used with the AC
power adapters supplied by the manufacturer, as included in this package.
Never cut, damage or bend the power cord.
•
Do not put any objects on top of the power cord, which could cause overheating, damage,
•
inflammation and electrocution.
•
Do not leave the power adapter connected to the wall outlet when it is not plugged into the Hub.
Advertisement
