Electronic Board Operations Check - Panasonic Panaboard UB-5310 Operating Instructions Manual

Electronic Board Operations Check

After assembling the electronic board, perform the procedures presented in the following table to make sure it
functions properly.
1 Turn on the power switch.
2 Open the printer door and load the
copy paper, then close the printer door.
• loading the copy paper procedure
(refer to the Operating Instructions
page 10)
3
Press .
4
Use the accessory marker to draw
a large
copyable area of the screen film
surface.
• Copying area (refer to the
Operating Instructions page 7)
Press
Press
5
Press
surface.
Write letters, etc. with the marker.
Press
Press
6
Press once.
7
Press .
40
Step
filling the entire
twice.
.
to move the screen film
once.
.
Points to Check
Symptom
" " flashes after " " lights up.
(If not)
" " lights up after the copy paper
is fed and automatically cut.
(If not)
Screen is fed.
The screen film surface is not fed
smoothly.
There are strange noises.
" " lights up and three copies
are made.
Three copies are not made.
The entire readable area is not
printed.
There are strange noises or
paper jams during the copying
process.
The Contrast indicator light is
turned on and copy is made.
The Contrast indicator light is
not turned on.
The image is not copied properly.
There are strange markings on
the copy sheet (e.g., stripes or
lines).
The Contrast indicator light is
not turned off.
Two screens are not copied
properly.
Solutions
(Normal operation)
Check power cord and
cables.
(See step 23 on page 39
and step 18 on page 38.)
(Normal operation)
Check the condition of
printer door or copy
paper roll.
(Normal operation)
Contact the store or
dealer from which the
unit was purchased.
(Normal operation)
Contact the store or
dealer from which the
unit was purchased.
(Normal operation)
Contact the store or
dealer from which the
unit was purchased.
Contact the store or
dealer from which the
unit was purchased.
Contact the store or
dealer from which the
unit was purchased.