Loading Copy Paper - Panasonic Panaboard UB-5310 Operating Instructions Manual

Loading Copy Paper

1
2
Door
Open
Button
3
4
5
Load a new roll when:
• Red bands become visible at the edge of the copy paper.
• The ERROR indicator "
10
Power
Switch
Copy paper
compartment
A
B
Paper feed
roller
Cutter cover
About 4 cm (1 1 / ")
2
" goes on and off even after the printer door is closed properly.
Turn the power switch on by pressing the " I " side
of the power switch.
• The unit is ready for use when "
multi-copy/error indicator.
• The screen will move to home position and stop.
Push the door open button and open the printer
door.
• If there is any copy paper remaining in the copy paper
compartment, remove it.
Load the copy paper roll with smooth side facing up.
Open the printer door to position B and load it, then
move the printer door to position A to prevent
paper roll from falling.
Loosen about
29
15 cm (5 / ")
32
as shown and
load it.
Note
• Use copy paper roll with a core diameter of 25.4 mm
(1 inch) or more. Using a copy paper roll with a smaller
core could cause paper jams.
Pass the paper over the paper feed roller and
under the cutter cover, then through the output port
about 4 cm (1 1 / inches).
2
Close the printer door securely, using two hands.
Note
• Once the door is closed, paper will feed and
automatically cut. Remove and discard the small piece
of paper.
" is displayed on the
Smooth side
Wrong direction
About
15 cm (5 29 / ")
32