Electronic Board Operations Check - Panasonic Panaboard UB-7320 Operating Instructions Manual

Electronic Board Operations Check

After assembling the electronic board, perform the procedures presented in the following table to make sure it
functions properly.
Step
1
Turn on the power switch.
2 Open the printer door and load the
copy paper, then close the printer
door.
• Loading the Copy Paper
procedure (refer to the
Operating Instructions on page
10)
3
Press
Press
4
Use the accessory marker to
draw a large
entire copyable area of the
screen film surface.
• Copyable area (refer to the
Operating Instructions on
page 7)
Press twice.
Press
5
Press
film surface. Write letters, etc.
with the marker.
Press once.
Press
6
Press once.
32
" " flashes after " " lights up.
(If not)
" " lights up after the copy
paper is fed and automatically
cut.
(If not)
Screen is fed.
.
The screen film surface is not
.
fed smoothly.
There are strange noises.
" " lights up and three copies
are made.
filling the
Three copies are not made.
The entire readable area is not
printed.
There are strange noises or
paper jams during the copying
process.
.
The Contrast indicator light is
to move the screen
turned on and one copy is made.
The Contrast indicator light is
not turned on.
The image is not copied
.
properly.
There are strange markings on
the copy sheet
(e.g., stripes or lines).
The Contrast indicator light is
turned off.
(If not)
Points to Check
Symptom Solutions
(Normal operation)
Check power cord. (See step 5
on page 31.)
(Normal operation)
Check the condition of printer
door or copy paper roll.
(Normal operation)
Contact the store or dealer
from which the unit was
purchased.
(Normal operation)
Contact the store or dealer
from which the unit was
purchased.
(Normal operation)
Contact the store or dealer
from which the unit was
purchased.
(Normal operation)
Contact the store or dealer from
which the unit was purchased.