Table of Contents
Advertisement
Close
FIG. 3.
NOTE: This machine is equipped with a pad
centerlock with a left hand thread.
ATTENTION: Care must be exercised to be sure
centerlock does not cross–thread or floor damage
could occur. Do not overtighten.
ATTENTION: Do not operate machine without a
pad and the pad centerlock in place.
MACHINE OPERATION
PRE OPERATION CHECKS
1. Check battery meter charge level to ensure
batteries are fully charged. See CHARGING THE
BATTERIES.
2. Sweep or dust mop the floor to remove debris.
Then damp mop or scrub the floor to assure that
dirt is not burnished into the finish.
3. Check that a pad is installed.
4. Check that a dust bag is installed.
5. Make sure floor to be burnished is dry.
BURNISHING WITH THE NON–DRIVE MODEL
ATTENTION: Loose objects on floor can become
dangerous projectiles if struck by the high speed
pad. Remove them before operating the machine.
1. Turn the key switch to the "ON" position
(Figure 4) . The key ON light on the panel will light
green.
BR-2250/BR-2500 (04–99)
Open
FIG. 4.
2. With the control grips released, step down on the
rear of the pad shroud until the head locks in the
down position (Figure 5).
FIG. 5.
3. Remove foot from the pad shroud.
4. Twist the control grips forward (Figure 6) . The pad
motor will start and suction will draw the moving
pad to the floor. Immediately push or pull the
machine in the desired direction.
FIG. 6.
ATTENTION: Keep the machine moving at all
times to prevent damage to the floor finish.
OPERATION
5
Advertisement
Table of Contents
