Table of Contents
Advertisement
OPERATION
5. Disconnect the battery connector from the
machine connector and plug the charger
connector into the battery connector
(Figure 18).
FIG. 18.
NOTE: Do not plug the charger connector into the
machine connector or damage to the machine may
occur.
6. Plug the charger cord into a wall outlet. The
charger will automatically start and charge the
batteries.
After charging:
7. Make sure that the charger has turned off by
making sure the needle on the charger is at "0".
8. Unplug the charger connector from the battery
connector. Plug the battery connector into the
machine connector.
9. Check all battery cells for low water level. Add
distilled water to just below the fill ring if needed.
10. Replace the battery caps.
11. Wipe off the top of the batteries with a clean cloth.
12. Slide the battery cover into place.
10
STORING MACHINE
The machine must be stored in a dry area in a
horizontal upright position.
SPECIFICATIONS
ITEM
Length
Width
Height
Weight: NON DRIVE MOD
EL
Weight: DRIVE MODEL
Speed: NON DRIVE MODEL Push
Speed: DRIVE MODEL
Pad Diameter/Burnishing
Path
Pad Motor
Pad Speed
Battery Life: NON DRIVE
MODEL
Battery Life: DRIVE MODEL
Decibel Level
MEASURE
1350 mm
550 mm
1020 mm
104 kg (excluding batteries)
118 kg (excluding batteries)
5 k/hr
483 mm
2,24 kW (3hp)
2,500 rpm
2,5 3,5 hours
2 3 hours
75 dBA
BR-2250/BR-2500 (04–99)
Advertisement
Table of Contents
