Machine Operation - Castex HS-1100 Operator And Parts Manual

5. Return machine to upright position after pad is
installed.
6. For easy power cord removal, pull and turn cord
hook upward (Figure 3).
7. Plug power cord into a grounded wall outlet
(Figure 4).
Grounded Outlet
Grounded
3 Hole Outlet
Ground Pin
(120V)
FOR SAFETY: Do not operate machine unless
cord is properly grounded or with the use of an
extension cord.

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
NOTE: Before operating machine, be certain that
floor is dry and clean of debris.
1. Lower handle by stepping down on handle release
foot lever (Figure 5).
HS-1100/1500/1900 (03–01)
FIG. 3
Grounding
Edge/hole
(230V/240V)
FIG. 4
FIG. 5
Home Find... Go To..
2. To begin burnishing, depress safety lock button
and pull triggers. Release safety lock button once
machine starts (Figure 6).
ATTENTION: Use caution when starting out.
Machine will jolt when triggers are pulled.
3. Push machine forward or use a "W" pattern
motion.
ATTENTION: Keep machine moving to prevent
floor surface damage.
4. To prevent motor overload, periodically check pad
for excessive soil build-up. Turn pad over, clean or
replace when necessary.
NOTE: If circuit breaker trips while operating, unplug
power cord, wait 15 seconds and reset breaker switch
to resume operation ( Figure 7).
5. To stop machine, release triggers and the safety
lock button will automatically engage.
FOR SAFETY: When using machine, do not
release handle grips until pad comes to complete
stop.
6. When finished burnishing, perform the
maintenance procedures.
OPERATION
FIG. 6
FIG. 7
5