Table of Contents
Advertisement
Preparation
The method to validate the Domain certificate requires installation of the certificate chain including
the Root certificate on to the Xerox device. The Xerox WorkCentre may be configured to validate all
certificates via OCSP (Online Certificate Status Protocol Responder). It submits the Domain Certificate
and any associated Intermediary Certificates to the OCSP Responder, to verify that these certificates
are valid and not revoked. The WorkCentre then receives a response from the OCSP responder stating
whether these certificates are valid.
Note:
Certificates are often obtained from the Information Technology professionals that support
your organization. The certificate chain consists of all Intermediate Certificates up to and
including the Root Certificate. If you are unable to obtain the required certificates, refer to the
process outlined in Appendix A. You can determine the domain that you are registered in using the
process outlined in Appendix B.
Server Specifications
Prior to installation, ensure your network infrastructure supports Common Access Card or Personal
Identification Verification (PIV).
Names or IP addresses of all servers and domains are required during setup.
Electrical Requirements
The USB port on the back of the Xerox device network controller provides the power required for any of
the supported card readers.
10
Xerox Common Access Card
Common Access Card Installation Guide
Advertisement
Table of Contents
Troubleshooting
