Operation - HAMPTON BAY Campbell II Use And Care Manual

Assembly - Assembling the Fan Without the Light kit
1
Assembling the fan without the
light kit
□
In order to use the fan without the light kit, remove the
switch cup cover (PP) from the top of the light kit fitter
assembly (E) by removing the center hex nut inside the
switch cup cover (PP), and then thread the switch cup cover
(PP) off of the threaded nipple on the top of the light kit
fitter assembly (E).
□
Press the plastic plug (HH) into the center hole of the
switch cup cover (PP).
□
Remove the three screws (RR) on the switch cup cover (PP).
□
Align the three holes in the switch cup cover (PP) with the
three holes in the switch cup of the fan-motor assembly
(D). Make sure the notch in the switch cup cover (PP) clears
the reversing switch in the switch cup of the fan-motor
assembly (D).
□
Re-install the three screws (RR) that were removed in first
step to secure the switch cup cover (PP).

Operation

OpERATING YOUR FAN
Turn on the power and check the operation of the fan. The fan pull
chain controls the fan speed as follows:
1 pull - High, 2 pulls - Medium, 3 pulls - Low, 4 pulls - off
The appropriate speed settings for warm or cool weather depends on
factors such as the room size, ceiling height, and number of fans.
The slide switch controls the direction of the blades: forward (switch
down) or reverse (switch up).
NOTE: Wait for the fan to stop before reversing the direction of the
blade rotation.
Warm weather - (Forward) A downward airflow creates a cooling effect.
This allows you to set your air conditioner on a higher setting without
affecting your comfort.
Cool weather - (Reverse) An upward airflow moves warm air off of the
ceiling. This allows you to set your heating unit on a lower setting
without affecting your comfort.
RR
12
D
PP
HH