HAMPTON BAY Campbell II Use And Care Manual page 8

Assembly - Close-To-Ceiling Mount
1
preparing for mounting
□
Remove the slide-on mounting bracket (A) from the canopy (C)
by loosening the four screws (SS) on the top of the canopy (C).
□
Remove the two non-slotted screws (SS) and loosen the slot-
ted screws (SS).
□
Remove the decorative canopy bottom cover (L) from the
canopy (C) by depressing the three studs.
SS
Assembly - Hanging the Fan
1
Attaching the fan to the electrical
box
WARNING: To reduce the risk of fire, electric shock
or personal injury, mount to an outlet box marked
"Acceptable for fan support of 35 lbs. (15.9 kg) or less,"
and use the screws provided with the outlet box.
□
Pass the 120-Volt supply wires through the center hole in the
slide-on mounting bracket (A).
□
Install the slide-on mounting bracket (A) on the outlet box by
sliding the slide-on mounting bracket (A) over the two screws (TT)
provided with the outlet box. If necessary, use leveling washers
(not included) between the slide-on mounting bracket (A) and
the outlet box. The flat side of the slide-on mounting bracket (A)
should face toward the outlet box, as shown.
□
Securely tighten the two mounting screws (TT).
2
Routing the wires
□
Remove three of the six screws and lock washers (QQ) (every
other one) securing the motor collar (M) to the top of the fan-
motor assembly (D).
□
Place the rubber gasket (EE) over the remaining three screws,
route the wires exiting the top of the fan-motor assembly (D)
through the canopy (C) (make sure the slot openings are on
top), and then place the canopy (C) over the collar at the top of
the fan-motor assembly (D).
□
A
Align the mounting holes with the holes in the motor and
fasten using the three screws and lock-washers (QQ) removed
previously. Tighten the mounting screws securely.
C
L
2
Hanging the fan
□
Carefully lift the fan-motor assembly (D) up to the slide-on
mounting bracket (A).
□
Seat the hanger ball portion of the ball/downrod assembly (B)
in the slide-on mounting bracket (A) socket. Ensure that the
tab on the slide-on mounting bracket (A) socket is properly
seated in the groove in the hanger ball. If using close-to-ceil-
ing mounting, hang the fan on the hook provided by utilizing
one of the holes at the outer rim of the ceiling canopy (C).
A
C
D
8
C
QQ
EE
WARNING: The hook is only to balance the fan while
making the electrical connections. Failure to hang as
shown may result in the hook breaking, causing the fan
to fall. The hook must pass from the inside to the outside
of the canopy (C).
M
D
A
B
C
D