Related Manuals for HAMPTON BAY 296 065
Summary of Contents for HAMPTON BAY 296 065
- Page 1 296 065 Casselberry Ceiling Fan Owner’s Manual Casselberry Ventilador de Techo de 1,32 Manual del Propietario...
- Page 2 Casselberry by Hampton Bay ®...
-
Page 3: Table Of Contents
52” Casselberry Thank you for purchasing our ceiling fan. This product has been manufactured with the highest standards of safety and quality. Ceiling Fan by Hampton Bay Date Purchased Table of Contents Store Purchased Safety Rules ....1 296-065 UL Model No. -
Page 4: Safety Rules
Safety Rules - Read and Save These Instructions To reduce the risk of electric shock, insure electricity has been turned off After making electrical connections, spliced conductors should be turned at the circuit breaker or fuse box before beginning. upward and pushed carefully up into outlet box. The wires should be spread apart with the grounded conductor and the equipment-grounding All wiring must be in accordance with the National Electrical Code conductor on one side of the outlet box and ungrounded conductor on the... -
Page 5: Unpacking Your Fan
Unpacking Your Fan Unpack your fan and check the contents. You should have the following items: Set of blades (4) Mounting plate Blade Attachment Hardware 3/16"×12.3 mm Screws with Fiber Blade support plates (4) Light kit Washers (13PCs.) Canopy assembly Glass shade Ball/downrod assembly 40W candelabra bulbs (3) -
Page 6: Installing Your Fan
Installing Your Fan Provide Strong Support Tools Required Figures 1~3 are examples of different ways to mount the outlet box. Phillips screwdriver, straight slot screwdriver, step ladder and wire cutters. Recessed Ceiling Outlet Box Mounting Plate Mounting Options Figure 3 Outlet Box Note: You may need a longer downrod to If there isn't an existing UL listed mounting box,... - Page 7 Hanging the Fan WARNING Cross pin FAILURE TO PROPERLY INSTALL COTTER PIN REMEMBER to turn off the power. Follow the AS NOTED IN STEP 5 COULD RESULT IN FAN Hanger ball LOOSENING AND POSSIBLY FALLING. steps below to hang your fan properly. Downrod Remove the canopy cover from the canopy by turning the cover counter clockwise.
-
Page 8: Installing Fan To The Electrical Box
Installing Fan to Slip coupling cover, canopy cover and canopy UL Listed Outlet Box onto downrod. Carefully reinstall hanger ball the Electrical Box onto rod being sure that cross pin is in correct position, set screws are tighten and wires are not twisted. -
Page 9: Making The Electrical Connections
Making the Electrical receiver. Secure the wire connections with the plastic wire connecting nuts provided. Connections Frequency Switch (Figure 14) Receiver to house supply wires electrical connections: Connect the black (hot) WARNING wire from the ceiling to the black wire marked TO AVOID POSSIBLE ELECTRICAL SHOCK, BE "AC in L"... - Page 10 WARNING WARNING SUPPLY CIRCUIT MAKE SURE THE TAB ON THE HANGING CHECK TO SEE THAT ALL CONNECTIONS ARE BRACKET PROPERLY SITS IN THE GROOVE IN TIGHT, INCLUDING GROUND, AND THAT NO THE HANGER BALL BEFORE ATTACHING THE BARE WIRE IS VISIBLE AT THE WIRE NUTS. Ground EXCEPT FOR THE GROUND WIRE.
- Page 11 Attaching the Fan Blades WARNING TO REDUCE THE RISK OF PERSONAL INJURY, DO NOT BEND THE BLADE HOLDERS WHILE CAUTION Touching Ceiling INSTALLING, BALANCING THE BLADES, OR MOTOR IS SHIPPED WITH RUBBER PACKING CLEANING THE FAN. DO NO INSERT FOREIGN MOUNTS TO PREVENT MOVEMENT DURING OBJECTS BETWEEN ROTATING FAN BLADES.
-
Page 12: Installing The Light Kit
Installing the Light Kit Installing the Mounting Plate CAUTION Install 3 x 40W candelabra bulbs (included). BEFORE STARTING INSTALLATION, DISCON- Remove 1 of the 3 screws from the mounting NECT THE POWER BY TURNING OFF THE Remove the decorative nut from the light kit ring and loosen the other 2 screws. - Page 13 Bulbs Wire Connectors Mounting Plate Mounting Plate Light Kit Light Kit Screws Figure 19 Glass Shade NOTE Decorative Nut LIGHT BULBS HAVE NO WARRANTY; CAN BE Figure 20 PURCHASED AT ANY HOME DEPOT STORE.
-
Page 14: Operating Your Transmitter
Operating Your Transmitter Installing the Battery: Restore power to the ceiling fan and test for proper operation. Install 12V MN21/A23 battery (included), to "HI, MED, LOW" buttons: prevent damage to transmitter, remove the battery These three buttons are used to set the fan if not used for long periods. - Page 15 Installing the Transmitter Speed settings for warm or cool weather depend on factors such as the room size, ceiling height, Holder number of fans, etc. Remove the two plugs from the holder. Note The Reverse switch is located on the top of motor that the plugs have unique tabs that allows housing.
-
Page 16: Care Of Your Fan
Remote control Do not connect the fan with a wall mounted variable speed control(s). Make sure the dip switches are set correctly. THE HAMPTON BAY FAN & LIGHTING CO. WARNING P. O. Box 395 MAKE SURE THE POWER IS OFF AT THE ELECTRICAL PANEL BOX Norco, CA 92860 BEFORE YOU ATTEMPY ANY REPAIRS. -
Page 17: Specifications
Specifications FAN SIZE SPEED VOLTS AMPS WATTS N.W. G.W. C.F. 0.35 12.0 1646.16 7.67 kgs 8.92 kgs 52" MED. 0.45 30.5 3301.60 2.06' (16.90 lbs) (19.62 lbs) 0.42 48.0 4850.00 HIGH These are approximate measures. They do not include Amps and Wattage used by the light kit. Distributed by Home Depot U.S.A., Inc. -
Page 18: Warranty Information
Lifetime Limited Warranty (lifetime warranty on motor) The Hampton Bay warrants the fan motor to be free from defects in workmanship and material present at time You must present a copy of the original purchase receipt to obtain warranty of shipment from the factory for a period of lifetime after the date of purchase by the original purchaser.