HAMPTON BAY Campbell II Use And Care Manual page 11

Assembly - Attaching the Lights
1
Attaching the light kit fitter assembly
CAUTION: To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before installing the
light fixture.
NOTE: Notice the location of the fan's slide switch. This is
the switch used to change the fan's directional rotation.
For more information on the operation of this switch, see
Operating Your Fan on page 12.
□
Remove the three screws (RR) on the switch cup cover of the
light kit fitter assembly (E).
□
Connect the wires from the light kit fitter assembly (E) to the
wires from the switch cup of the fan-motor assembly (D) by
connecting the molded adaptor plugs together (blue to black,
white to white). Carefully tuck all wires and splices into the
switch cup.
□
Align the three holes in the switch cup cover of the light kit
fitter assembly (E) with the three holes in the switch cup
of the fan-motor assembly (D). Make sure the notch in the
switch cup cover of the light kit fitter assembly (E) clears the
reversing switch in the switch cup of the fan-motor assembly
(D). Position the light kit fitter assembly (E) and re-install the
three screws (RR) that were removed in first step to secure
the light kit fitter assembly (E).
RR
2
D
E
11
Installing the bulbs and glass bowl
WARNING: Allow the glass bowl to cool completely before
removing.
WARNING: Over lamping the light kit will result in the lights
shutting down until the proper wattage of bulbs are installed.
Reset the lights by turning off the light kit, replace the bulbs
with the correct wattage bulbs, and turn the light kit back on.
CAUTION: Make sure the power is off before attaching or
removing the glass bowl.
CAUTION: Do not over tighten the hex nut, overtightening the
hex nut may cause the glass to break.
□
Remove the finial and the bottom cover from the threaded
nipple of the light kit fitter assembly (E).
□
With the power off, install the two incandescent bulbs (I) by
screwing them into the light bulb sockets.
□
Position the glass bowl (H), re-install the bottom cover over
the threaded nipple, and direct the fan pull chain through the
side hole of the bottom cover.
□
Re-install the finial over the threaded nipple and direct the
light pull chain through the hole of the finial, and tighten the
finial securely.
□
Attach the pull chain extensions (II) provided to the light pull
chain and fan pull chain.
D
E
H
II
Please contact 1-877-527-0313 for further assistance.
I
HAMPTONBAY.COM