Bajaj pulsar DTS-i Service Station Manual page 65

IMPORTANCE OF PM SCHEDULE EXECUTION
CO% Setting
Pulsar 150/180 DTS-i
Service Station Manual
1. Readiness of CO gas analyzer
a. Ensure the machine is in well calibrated condition & calibration
certificate is available.
b. Switch ON & warm up the CO gas analyzer for its recommended
time.
c. Then carry out various tests such as leakage test, HC residue test,
IR zero test, oxygen censor test etc.
2. Readiness of the Vehicle
a. Warm up the engine. Run the vehicle on MRTB or drive the vehicle
for about 3 ~ 4 kms on road.
b. After warm up, check the engine oil temperature by dipping the probe of
temperature indicator in the oil through oil filler cap.
0
It must be 60 c.
3. Check & set engine idling RPM with the use of digital tachometer to
1400 + 100 by adjusting idling screw.
4. Remove bolt & washer fitted to the silencer nozzle near to ExhausTEC.
5. Connect silicon tube of CO gas analyzer probe to the nozzle.
6. Note the CO when reading on LCD screen of the analyzer stabilizes.
61
Dealer Development Center
Akurdi Pune