Bajaj pulsar DTS-i Service Station Manual page 57

IMPORTANCE OF PM SCHEDULE EXECUTION
Pulsar 150/180 DTS-i
Service Station Manual
10. Clean the 'Oil Strainer' by kerosene / diesel & nylon brush.
11. Blow low pressure air (2 bar) on the strainer mesh in the direction
opposite to flow of oil.
12. Pump the engine oil by 'Oil can' through the input passage hole of oil
pump body & simultaneously rotate the oil pump shaft nylon gear in
clockwise direction to ensure clear oil passage & working of oil pump.
13. Check condition of 'O' ring of 'Oil Strainer'. Re-install the oil strainer on
oil pump body. Refit the clamp securing 'Oil Strainer'.
Required Special Tools & Equipment
T Spanner
53
Nylon Brush
Dealer Development Center
Air Gun
Akurdi Pune