Varia eRTL615 Status LED
LED State
Flashing purple
Flashing blue
Single blue flash
Double blue flash
Flashing yellow
Flashing blue and green alter
nating
Flashing green 10 times
Flashing red 10 times
Solid red
Tail Light Modes and Intensity
You can switch the Varia eRTL615 tail light modes by pressing the button
Mode
Solid (default)
Peloton (group ride)
Night Flash
Day Flash
Standby
Turning Off the Varia eRTL615 Tail Light
Hold the device button for 2 seconds
The radar continues to function while the tail light is off.
The Varia eRTL615 and Your Edge 1040
You can remotely control your radar device and customize settings using your compatible Edge bike computer.
This section contains instructions for the Edge 1040. Other compatible Edge bike computers contain similar
settings and controls
(Other Compatible Devices,
The Varia eRTL615 and Your Edge 1040
Status
The device is in active pairing mode.
The device is in smart mode and can be controlled by a paired compatible
Garmin device.
The device entered smart sleep mode.
The device entered active mode.
The device is in demo mode.
The device is applying a firmware update.
The device successfully applied a firmware update.
The device was unable to apply a firmware update.
An error occurred. You may need to restart the device.
Light Intensity
High
Moderate
High
Maximum
Off
(Device Overview,
page 12).
(Device Overview,
Default Flash Behavior
None
None
Slow
Occasional
None
page 4).
page 4).
Function
The tail light is on, and the
device detects vehicles.
The tail light flashes softly
when the device detects
vehicles.
The tail light flashes
quickly when the device
detects vehicles.
The tail light flashes
quickly when the device
detects vehicles.
The tail light is off, and the
device continues to detect
vehicles.
5