Table of Contents
Advertisement
Introduction
See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
The device can improve situational awareness. It is not a
replacement for cyclist attentiveness and good judgement.
Always use your best judgment, and operate the bicycle in a
safe manner.
Getting Started
You can use the Varia RTL (radar taillight) with the Varia RDU
(radar display unit) or with your compatible Garmin
list provides an overview of the installation and setup tasks.
• Charge the device
(Charging the Device, page
• Install the universal mount
page
1).
• If you are using the Varia RDU, install it on your bike stem or
handlebar
(Installing the Varia RDU Device, page
NOTE: When you purchase the Varia RTL and RDU devices
together, they are already paired.
• If you are using an Edge
(Pairing the Taillight with Your Edge 1030, page
• If you are using another Garmin device, pair the devices
(Other Compatible Devices, page
Tips for Installing the Device
The Varia RTL device includes a taillight and micro radar that
can detect approaching vehicles up to 140 meters away.
• Select a secure location to mount the device where it does
not interfere with the safe operation of your bike.
• Mount the device as high on the seat post as possible for
optimal light visibility and radar detection.
NOTE: The mount surface should be vertical. There is a 15-
degree angle between vertical and a typical seat post.
• Mount the Varia RTL511 device on the seat post 250 mm to
1200 mm above the road.
• Install the device correctly.
The device faces backward and is perpendicular to the road.
• Go for a test ride during the day in a safe environment.
Installing the Universal Mount
1
Select a rubber pad
place the rubber pad on the back of the universal mount.
2
Place the universal mount on the seat post.
Introduction
WARNING
®
device. This
4).
(Installing the Universal Mount,
1030 device, pair the devices
®
2).
4).
based on your seat post shape, and
3
Attach the universal mount securely using one band
4
Align the tabs on the back of the device with the universal
mount notches
5
Press down slightly and turn the device clockwise until it
locks into place.
Device Overview
2).
Device key Press to change light modes.
Status
LED
Varia RTL Status LED
LED Activity
Flashing purple
Flashing blue
Flashing red
Flashing green
Solid green
Solid red
Alternating blue and
green
Turning Off the Taillight
Hold the device key for 2 seconds.
.
Hold for 1 second to turn the device on.
Hold for 2 seconds to enter pairing mode when the
device is turned off.
Hold for 2 seconds to turn the device off.
Changes color based on the battery level, pairing
status, and charging status.
Status
The device is in pairing mode.
The device is in smart mode and can be
controlled by a paired Varia RDU or
compatible Garmin device.
The battery is low.
The device is charging.
Charging is complete.
An error occurred while charging.
The device is updating software.
.
1
Hide quick links:
Advertisement
Table of Contents
