Stihl FS 55 Instruction Manual page 16

English
4
3
5
6
7
Fit the clamp (3) in the loop
N
handle (4) and place them both on
the drive tube (5).
Place the clamp (6) in position.
N
Place the barrier bar (2) in position
N
as shown.
Line up the holes.
N
Insert the screws (7) and tighten
N
them down moderately against the
barrier bar.
Go to "Securing the loop handle".
N
14
Loop handle without barrier bar
2
Fit the clamp (3) in the loop
N
handle (4) and place them both on
the drive tube (5).
Place the clamp (6) in position.
N
Line up the holes.
N
Fit washers (7) on the screws (8)
N
and insert the screws in the holes.
Fit the square nuts (1) and screw
them down as far as stop.
Go to "Securing the loop handle".
N
8
8
7
7
4
3
5
6
1
1
Securing the loop handle
A
9
10
Secure the loop handle (4) about
N
20cm/8in (A) forward of the control
handle (9).
Line up the loop handle.
N
Tighten down the screws firmly –
N
lock the nuts if necessary.
The sleeve (10) (not fitted on all models)
must be between the loop handle and
the control handle.
FS 55, FS 55 C, FS 55 R, FS 55 RC
4