Important Safety Instructions - IPS Controllers M920 Owner's Manual

M920 & M920W pH/Dual ORP Controller Owner's Manual

IMPORTANT SAFETY INSTRUCTIONS

B.
READ AND FOLLOW ALL
1.
INSTRUCTIONS.
2. Risk of electric shock: Connect the controller to a dedicated ground-
fault circuit interrupter (GFCI) circuit breaker.
a. A green colored terminal or a terminal marked G, GR, Ground,
Grounding, or the
terminal box or compartment. To reduce the risk of electrical
shock, this terminal must be connected to the grounding means
provided in the electrical supply service panel with a continuous
copper wire equivalent in size to the circuit conductors
supplying this equipment.
*IEC Publication 417, Symbol 5019.
3. Disconnect power before servicing the controller.
4. Inspect all power cords frequently. Any damaged cords should be
replaced immediately to reduce the risk of injury by shock.
5. Always maintain a record of manual water chemistry readings using
an accurate test kit. Automated controllers are not a substitute for
this Health Department requirement.
WARNING
6.
children to use this product unless they are closely supervised at all
times.
7. Danger – Risk of injury.
a. Replace damaged cord immediately.
b. Do not bury cord.
c. Connect to a grounded, grounding type receptacle only.
WARNING
8.
(1.5m) from inside wall of water enclosure using non-metallic
plumbing.
9. Operation of this controller without a functioning flow-switch will
void the NSF Certification.
WARNING
10.
accessible to the public.
SAVE THESE INSTRUCTIONS
11.
symbol* is located inside the supply
– To reduce the risk of injury, do not permit
– Risk of electric shock. Install at least 5 feet
– Do not install this controller where it is
3
.