Remote Monitoring Setup - IPS Controllers M920 Owner's Manual

M920 & M920W pH/Dual ORP Controller Owner's Manual
C. Remote Monitoring Setup
1. New Account Registration
a. Go to monitor.ipscontrollers.com -> Select Register and enter a
valid email address, and then select Submit. Website will send a
verification email to the address entered.
b. Click link in email to complete registration. Once completed the
account Dashboard will be displayed.
2. Adding a New Controller
a. Do not add a controller without first creating or selecting a
Location (step b).
b. From the Dashboard choose Settings and then Locations. If the
location for the controller already exists, select that location and
then select Add Controller. If the Location does not exist select
Add Location and enter the Location Name (facility) and Time
Zone. Once the Location is added, select the Location and then
select Add Controller.
c. Enter the Controller Name (Pool, Spa, Wader etc.), the MAC
Address or Serial # (found on the bottom of the Left side panel
of the controller). Note: all letters must be in CAPS and any
character that looks like a Zero is a Zero. Choose the Model #
(VP200, M920 or M920-CA) and then select Add Controller. Do
not select "Existing". Allow five to ten minutes for the controller
data to update completely on the Dashboard.
3. Adding Additional Users
a. From the Dashboard select Settings and then Controllers. Select
the location and then the controller to add a user to.
b. Select Add Users at the bottom right of the page. Enter User's
Email Address, First and Last Name. Finally, choose to allow (or
not) the user to set their own Notifications and to make changes
to the controller's program. Select Add User (if user does not
have a registered account a verification email will be sent).
c. The user will need to be added to each controller using the first
two steps above (verification email will only be sent once).
32